# Bends and Elbows [49 CFR 192.313]

- **operation:** document
- **citation:** LAC 43:XIII §1713
- **title:** Bends and Elbows [49 CFR 192.313]
- **source type:** regulation
- **agency:** Louisiana Office of Conservation
- **status:** current
- **official:** true
- **published on:** Not available
- **effective on:** Not available
- **summary:** A. Each field bend in steel pipe, other than a wrinkle bend made in accordance with §1715, must comply with the following. [49 CFR 192.313(a)] 1. A bend must not impair the serviceability of the pipe. [49 CFR 192.313(a)(1)] 2. Each bend must have a smooth contour and be free from buckling, cracks, o
- **machine formats:** - **json:** https://regulus.evalyn.ai/document/la-lac-43-xiii-1713.json
- **markdown:** https://regulus.evalyn.ai/document/la-lac-43-xiii-1713.md
- **app url:** https://regulus.evalyn.ai/document/la-lac-43-xiii-1713
- **source url:** https://www.doa.la.gov/doa/osr/louisiana-administrative-code/
**body:**

A. Each field bend in steel pipe, other than a wrinkle bend made in accordance with §1715, must comply with the following. [49 CFR 192.313(a)]

1. A bend must not impair the serviceability of the pipe. [49 CFR 192.313(a)(1)]

2. Each bend must have a smooth contour and be free from buckling, cracks, or any other mechanical damage. [49 CFR 192.313(a)(2)]

3. On pipe containing a longitudinal weld, the longitudinal weld must be as near as practicable to the neutral axis of the bend unless: [49 CFR 192.313(a)(3)]

a. the bend is made with an internal bending mandrel; or [49 CFR 192.313(a)(3)(i)]

b. the pipe is 12 inches (305 millimeters) or less in outside diameter or has a diameter to wall thickness ratio less than 70. [49 CFR 192.313(a)(3)(ii)]

B. Each circumferential weld of steel pipe which is located where the stress during bending causes a permanent deformation in the pipe must be nondestructively tested either before or after the bending process. [49 CFR 192.313(b)]

C. Wrought-steel welding elbows and transverse segments of these elbows may not be used for changes in direction on steel pipe that is 2 inches (51 millimeters) or more in diameter unless the arc length, as measured along the crotch, is at least 1 inch (25 millimeters). [49 CFR 192.313(c)]

D. An operator may not install plastic pipe with a bend radius that is less than the minimum bend radius specified by the manufacturer for the diameter of the pipe being installed. [49 CFR 192.313(d)]

AUTHORITY NOTE: Promulgated in accordance with R.S. 30:501 et seq.

HISTORICAL NOTE: Promulgated by the Department of Natural Resources, Office of Conservation, LR 9:232 (April 1983), amended LR 10:524 (July 1984), LR 27:1542 (September 2001), LR 30:1246 (June 2004), LR 46:1586 (November 2020).
- **truncated:** false
- **body characters:** 1777