# Petroleum Transportation & Storage Association — Hazardous Materials Safety Interpretation

- **operation:** document
- **citation:** 07-0235
- **title:** Petroleum Transportation & Storage Association — Hazardous Materials Safety Interpretation
- **source type:** guidance
- **agency:** Pipeline and Hazardous Materials Safety Administration
- **status:** guidance
- **official:** true
- **published on:** 2008-02-28
- **effective on:** Not available
- **summary:** 07-0235 response to Petroleum Transportation & Storage Association concerning 172.101.
- **machine formats:** - **json:** https://regulus.evalyn.ai/document/phmsa-interpretation-07-0235.json
- **markdown:** https://regulus.evalyn.ai/document/phmsa-interpretation-07-0235.md
- **app url:** https://regulus.evalyn.ai/document/phmsa-interpretation-07-0235
- **source url:** https://www.phmsa.dot.gov/sites/phmsa.dot.gov/files/legacy/interpretations/Interpretation%20Files/2007/070235.pdf
**body:**

<<<PAGE 1>>>

U.S. Department
of Transportation
Pipeline and Hazardous
Materials Safety
Administration
1200 New Jersey Avenue. SE
Washington, D.C. 20590
Mr. Mark Morgan, Esq.
Regulatory Counsel
Petroleum Transportation & Storage Association
4200 Wisconsin Avenue NW, Suite 106
Washington, DC 200 16
Ref. No. 07-0235
Dear Mr. Morgan:
This responds to your December 20,2007 email and provides further clarification of our
November 28,2007 letter (Ref. No. 07-100) concerning proper shipping names for certain
petroleum distillate fuel and biodiesel blends under the Hazardous Materials Regulations
(HMR; 49 CFR Parts 17 1 - 180). Specifically, you ask the ap ropriate proper shipping P
names for blends of heating oil and biodiesel (i.e., BioheatB ) and blends of kerosene and
biodiesel.
It is our understanding that biodiesel refers to a non-hazardous (for purposes of the HMR)
fuel derived from vegetable oils or animal fats. Biodiesel may be blended with various
petroleum distillate hels, such as No. 1 or No. 2 diesel, kerosene, and heating oil. Shippers
of petroleum distillate fuels routinely describe the materials using the trade name of the
material (e.g., diesel fuel, fuel oil, heating oil, kerosene). Shippers of biodiesel blends
similarly use the same trade name to describe a biodiesel blend - thus, shippers typically
will use the term "heating oil" to identify heating oil/biodiesel blends or "kerosene" to
identify kerosene/biodiesel blends.
A hazardous material must be described using an appropriate proper shipping name from
the Hazardous Materials Table (HMT) in § 172.10 1 of the HMR. In accordance with
$ 172.10 1 (c)(1 O), a mixture or solution not identified by name in the HMT that is composed
of a non-hazardous material and a hazardous material identified in the HMT by a technical
name must be described using the proper shipping name of the hazardous material and the
qualifying word "mixture" or "solution," as appropriate. However, if a material can be
appropriately described by a proper shipping name that suggests its intended application,
the addition of the qualifying word "mixture" or "solution" is not required (see
1 72.10 1 (c)(l O)(i)(F)).
' BioheatB is a registered trademark of the National Biodiesel Board.

<<<PAGE 2>>>

It is the opinion of this office that a biodiesel fuel blend may be appropriately described
using a proper shipping name that describes its intended application. Thus, a blend of
heating oil and biodiesel may be described as "Heating oil;" a blend of fuel oil and
biodiesel may be described as "Fuel oil," a blend of kerosene and biodiesel may be
described as "Kerosene," and a blend of diesel fuel and biodiesel may be described as
"Diesel fuel." Since these names describe the material's intended application, the addition
of the qualifying word "mixture" or "solution" is not required. If an appropriate proper
shipping name is not provided in the HMT, the most appropriate generic or n.0.s.
description for the material must be used (e.g., "Petroleum distillates, n.0.s."). See
$ 172.101(~)(12)(ii).
This guidance differs from guidance provided in our November 28 response on this issue,
and I apologize for any confusion that may result. As you know, a wide variety of biodiesel
blends may be produced using an equally wide variety of petroleum distillate fuels,
depending on consumer needs or state requirements. It is our understanding that these
blends pose flammable or combustible hazards that are similar to the hazards of the original
petroleum distillate fuels utilized in the blend. Therefore, describing these materials using
proper shipping names that describe their intended application addresses the safety risks
they pose and the emergency response procedures that should be used in the event of an
accident. As the biofuels industry evolves, we will continue to consider how best to
identify biofuel blends on shipping papers and how to communicate potential hazards to
transport workers and emergency response personnel. We would welcome suggestions
from the industry on this issue.
I hope this information is helpful.
Sincerely,
$A---yy& Edward T. Mazzullo
Director, Office of Hazardous Materials Standards
Cc: John L. Conley
National Tank Truck Carriers, Lnc.
Richard Moskowitz
American Trucking Association
Michael Ritchie
Minnesota Department of Transportation

<<<PAGE 3>>>

8/72. /Q/
Proper fi/lp/~p
' ,44447~
- dZ-33-
Drakeford, Carolyn <PHMSA>
" - * - - - - a * "
From: DerKinderen, Dirk <PHMSA>
Sent: Thursday, December 20, 2007 2.1 1 PM
To: Drakeford, Carolyn <PHMSA>
Subject: FW: Bio-heat
Carolyn,
Can you enter this e-mail as all interp letter as well.
Thanks,
Dirk
- - " - - - - - A " " -
From: Mazzullo, Ed <PHMSA>
Sent: Thursday, December 20, 2007 11:47 AM
To: DerKinderen, Dirk <PHMSA>
Cc: Gorsky, Susan <PHMSA>
Subject: MI: Bio-heat
Please develop a response.
From: Mark S. Morgan, Esq. [mailto:mmorganptsa@cox.net]
Sent: Thursday, December 20, 2007 11:09 AM
To: Mazzullo, Ed <PHMSA>
Subject: Bio-heat
Ed:
Questions have arisen as a result of the Interpretation Letter on biodiesel blends. I feel like I have whacked a
hornet's nest. Primarily, how should blends of bio-heat (mixture of heating oil and biodiesel) to be entered on
shipping papers? These guys are really concerned that they have the right language.The blending percentages
vary. Also, what about bio-diesel mixed with kerosene?
Thanks
Mark
Mark S. Morgan, Esq.
Regulatory Counsel
Petroleum Marketers Association of America
New England Fuel Institute
Petroleum Transportation and Storage Association
4200 Wisconsin Avenue, N.W., Suite 106
Washington, D.C. 20016
(202) 364-6767
- **truncated:** false
- **body characters:** 5646
