Pipeline Safety Interpretation PI-75-0116

Page 1PI-75-0116 December 2, 1975 Mr. J.L. Williams Williams Brothers Engineering Company 6600 South Yale Avenue Tulsa, OK 74136 Dear Mr. Williams: This is with regard to the telephonic conversation between you and Mr. George L. Mocharko of this Office concerning installing gas pipelines uncased under a hard surface road. Your interpretation of 49 CPR §192.103, §192.105, and §192.111(b)(2) is correct per your letter and attachments dated August 4, 1975. We trust this adequately responds to your inquiry. Sincerely, SIGNED Cesar DeLeon Acting Director Office of Pipeline Safety Operations#

Page 2Williams Brothers Engineering Company 6600 South Yale Avenue Tulsa, Oklahoma 74136 July 31, 1975 U. S. Department of Transportation Office of Pipeline Safety Washington, D. C. 20590 Attention: Mr. Ceasar De Leon Subject: Interpretation of Sub-Sections 192.103, 192.105, and 192.111(b)(2) Gentlemen: Attached is a print of our Figure 1-12. Sub-sections 192.103, 192.105(a) and 192. 111(b)(2) deal with external loads, design formula for steel pipe, and design factor (F) for steel pipe. The attached Figure 1-12 is an example that illustrates our interpretation of these sub-sections of the code. Basically our interpretation is that for any given pipe size and wall thickness; and for a given design factor (F) the design pressure (internal pressure allowed) will be a lesser pressure when installed uncased under a hard surface road than when installation results in parallel encroachment on roads right-of-way. Our interpretation is based upon: A. 192. 103 Pipe must be designed with sufficient wall thickness, or must be installed with adequate protection to withstand anticipated external pressures and loads that will be imposed on the pipe after installation. B. 192.105 (a) t = Nominal wall thickness of the pipe in inches. ... additional wall thickness required for concurrent external loads in accordance with 192.103 may not be included in computing design pressure. C. API RP 1102 Fourth Edition, September 1968 - Recommended Practice for Liquid Petroleum Pipelines Crossing Railroads and Highways Paragraphs 3.1 a, b, and c. Using this information Figure 1-12 has been constructed and indicates that for 12.75" 0.D. x .255" W. T., X-60 pipe the design pressure would be limited to 1350 psig for an uncased road crossing of a hard surfaced road in a Class 1.location, while the design pressure for the same pipe would be 1440 psig for parallel encroachment on highways or public streets in a Class I location. Please advise if you concur with our interpretation of the regulations. Your prompt consideration of this matter will be appreciated. Yours very truly, WILLIAMS BROTHERS ENGINEERING COMPANY J. L. Williams Attachment#