Add to project

Projects

No projects yet

Export Official source

All sections

Browse regulation

Subpart A—Introduction, Approvals and Reports8

Subpart B—General Design Requirements11

Subpart C—Specifications for Pressure Tank Car Tanks (Classes DOT-105, 109, 112, 114 and 120)31

Subpart D—Specifications for Non-Pressure Tank Car Tanks (Classes DOT-111AW, 115AW, and 117AW)69

Subpart E—Specifications for Multi-Unit Tank Car Tanks (Classes DOT-106A and 110AW)20

Subpart F—Specification for Cryogenic Liquid Tank Car Tanks and Seamless Steel Tanks (Classes DOT-113 and 107A)44

Regulationcurrent

49 CFR 179.200-22

-22 Test of tanks.

Current as of 2026-08-18 Government source

eCFR editorial compilationAuthoritative but unofficial

View source

(a)Each tank shall be tested by completely filling the tank and dome or nozzles with water, or other liquid having similar viscosity, of a temperature which shall not exceed 100 °F. during the test; and applying the pressure prescribed in § 179.201-1. Tank shall hold the prescribed pressure for at least 10 minutes without leakage or evidence of distress. All rivets and closures, except safety relief valves or safety vents, shall be in place when test is made.#

(b)Insulated tanks shall be tested before insulation is applied.#

(c)Rubber-lined tanks shall be tested before rubber lining is applied.#

(d)Caulking of welded joints to stop leaks developed during the foregoing tests is prohibited. Repairs in welded joints shall be made as prescribed in AAR Specifications for Tank Cars, appendix W (IBR, see § 171.7 of this subchapter).#