Add to project

Projects

No projects yet

Export Official source

All sections

Browse regulation

Subpart A—Introduction, Approvals and Reports8

Subpart B—General Design Requirements11

Subpart C—Specifications for Pressure Tank Car Tanks (Classes DOT-105, 109, 112, 114 and 120)31

Subpart D—Specifications for Non-Pressure Tank Car Tanks (Classes DOT-111AW, 115AW, and 117AW)69

Subpart E—Specifications for Multi-Unit Tank Car Tanks (Classes DOT-106A and 110AW)20

Subpart F—Specification for Cryogenic Liquid Tank Car Tanks and Seamless Steel Tanks (Classes DOT-113 and 107A)44

Regulationcurrent

49 CFR 179.300-12

-12 Protection of fittings.

Current as of 2026-08-18 Government source

eCFR editorial compilationAuthoritative but unofficial

View source

(a)Tanks shall be of such design as will afford maximum protection to any fittings or attachment to the head including the housing referred to in § 179.300-12(b). Tank ends shall slope or curve inward toward the axis so that the diameter at each end is at least 2 inches less than the maximum diameter.#

(b)Loading and unloading valves shall be protected by a detachable protective housing of approved design which shall not project beyond the end of the tank and shall be securely fastened to the tank head. Pressure relief devices shall not be covered by the housing.#