Add to project

Projects

No projects yet

Export Official source

All sections

Browse regulation

Subpart A—Introduction, Approvals and Reports8

Subpart B—General Design Requirements11

Subpart C—Specifications for Pressure Tank Car Tanks (Classes DOT-105, 109, 112, 114 and 120)31

Subpart D—Specifications for Non-Pressure Tank Car Tanks (Classes DOT-111AW, 115AW, and 117AW)69

Subpart E—Specifications for Multi-Unit Tank Car Tanks (Classes DOT-106A and 110AW)20

Subpart F—Specification for Cryogenic Liquid Tank Car Tanks and Seamless Steel Tanks (Classes DOT-113 and 107A)44

Regulationcurrent

49 CFR 179.103-1

-1 Type.

Current as of 2026-08-18 Government source

eCFR editorial compilationAuthoritative but unofficial

View source

(a)Tanks built under this section may be of any approved cross section.#

(b)Any portion of the tank shell not circular in cross section shall have walls of such thickness and be so reinforced that the stresses in the walls caused by a given internal pressure are no greater than the circumferential stresses which would exist under the same internal pressure in the wall of a tank of circular cross section designed in accordance with paragraphs § 179.100-6 (a) and (b), but in no case shall the wall thickness be less than that specified in § 179.101.#

(c)[Reserved]#

(d)Valves and fittings need not be mounted on the manway cover.#

(e)One opening may be provided in each head for use in purging the tank interior.#